Site Search Type in your search
terms & hit "Enter"





All Specter products are
proudly made in the USA

Follow us on Facebook







Enter your email address
to join our mailing list!


  Home > 3 Point Slings > SOP Slings > Shotgun SOP Slings >


Mossberg 500
Standard Stock
SOP 3 Point Tactical Sling

Mossberg 500 Standard Stock 500 SOP Sling


 
Alternative Views:


Mossberg 500 Standard Stock SOP Sling

Our Price: $48.51


Product Code: 181

Color Options

Colors*:
  
Sling ERB Options

Emergency Release Buckle Options*:
  

Qty:
Description
 
This sling is designed to fit standard stock 12ga. Mossberg 500 shotguns.

These slings are:
  • 1.5" wide
  • Fully ambidextrous
  • Available with or without an Emergency Release Buckle (ERB)
  • Supplied with a matte finish steel side front sling mount plate and stirrup type webbing rear adapter


In order to attach this sling to your shotgun a simple and easy modification to the magazine bolt is required.

Click HERE for instructions on how to perform this modification.

Important: The Mossberg 500 & 590 use completely different front sling mount plates. Be sure to order the correct sling for the correct shotgun. The best way to tell the difference is that the 500 uses a bolt to connect the barrel to the mag tube. The 590 uses a threaded cap to connect the barrel to the mag tube. Occasionally some 500's come equipped with 590 mag tubes. So... order based on mag tube type.




Features

When we designed the SOP sling our intent was to produce the ultimate tactical patrol sling design, incorporating every positive feature suggested to us by end users as well as addressing, and solving, every negative issue relating to conventional 3 point sling designs that we had identified.

Since it's introduction into the marketplace, the SOP Sling has been called the next evolutionary step in 3 point tactical sling design. Here are a few reasons why and how it differs from our standard CQB Slings.

To begin with 1.5" wide webbing is used for the sling strap. It's exactly the same type of webbing used on our CQB Slings except for being wider. The purpose of the 1.5" width is to better distribute the weight of the weapon.

The next difference has to do with how the sling attaches to the weapon. We feel that a good sling design should work with the weapon, not against it. Conventional 3 point slings that are solidly attached to the side of the weapon don't hang well in anything but the Off Side Drop carry mode and have a tendency to bind up and limit efficient movement of the weapon during positional shooting. So, for the SOP Sling, we chose flexible 1" attachment straps to be used at each end of the sling to interface with the mounting adapter sling loops or sling swivels. The 1" straps move, shift and conform within the sling loops to allow the SOP Sling to move more efficiently with the weapon thus enhancing free movement of the weapon and allowing the weapon to hang in a more vertical orientation while being used in the Military Patrol Ready carry mode.

Another change is the ability for this sling to be set up for left or right handed operators. All of our SOP mounting adapters (If applicable) are set up with right and left hand mounting points. With the attachment strap feature it's a simple matter to attach the sling to the mounting adapters for use on either side. So, there is no right or left hand specific version necessary. The adapter strap feature also allows the user the flexibility to experiment with user specific custom mounting solutions.

Those are all great features. However, the feature that sets this sling apart from any other is the Transition Release Buckle (TRB). The TRB allows the sling to be quickly and efficiently extended to instantly create slack that allows for easy left/right shoulder transitions. This feature addresses a common complaint associated with conventional 3 point tactical sling designs. With those types of slings it's very difficult, if not impossible in some cases, to execute a cross shoulder transition. This creates a serious problem in an urban environment.

With the TRB feature the sling can be used exactly like a conventional 3 point design, allowing all of the same carry options. However, when the need to cross shoulder transition is anticipated, simply flip the TRB release with the non firing hand thumb and the 3rd point of the sling is silently released to slide freely along the sling allowing you to extend and mount on the opposite shoulder. The sling, however, is still attached and still functional allowing you to "let it hang" should a secondary weapon transition be called for.

When the time comes to re-lock the TRB, it can done so quickly, silently, and with just one hand needed, allowing the shooter to maintain a constant firing grip on the weapon. The TRB can also be locked in wherever the shooter finds it comfortable. This feature allows for convenient expansion and contraction of the sling's body loop as the operator's mission profile changes and more, or less, load bearing equipment is worn.